Firewood Calculator

Calculate cords of firewood needed for heating season by home size and insulation quality.

By Konstantin Iakovlev · Updated October 2026 · Source: Penn State Extension — Heating with Wood: An Introduction · Methodology

sqft
months
Wood Type
Burned In
$

Cords Needed

2.7

Est. Cost

$929.69

Firewood Estimate

Cords Needed2.7
Cost per Cord$340.00
Total Wood Cost$929.69
Heat Needed for the Season53M BTU
Natural Gas Furnace (90% efficient)$863.33
Electric Resistance Heat$2,769.64

Gas at $1.48 a therm (EIA 2025 residential average) and electricity at 18 cents a kWh. A heat pump delivers two to three units of heat per unit of electricity, so it would cost a half to a third of the electric figure.

Use the Firewood Calculator above to calculate your results. Enter your values and see instant results — all calculations run in your browser.

Disclaimer: This calculator is for informational purposes only. Results are estimates based on the information you provide and the assumptions described on this page.

How It Works

Ordering the right amount of firewood for the heating season is a balancing act. Buy too much and you tie up storage space while logs sit long enough to spoil; buy too little and you risk running out mid-winter, when last-minute deliveries get expensive fast. Pinning down your real need protects both your budget and your comfort.

The estimate runs on a simple BTU-based method. The season's heat need is your square footage times a fixed figure for insulation quality (25,000 BTU per sq ft for good, 35,000 for average, 50,000 for poor) over a five-month season, scaled for the number of months you enter. That heat need is an assumption, not a measurement, and there is no climate input or target temperature. It is divided by the heat a cord delivers: 24 million BTU for air-dried hardwood such as red oak or sugar maple (Penn State Extension; hickory carries 28.0 million) or a rough 15 million for softwood, times the efficiency of what you burn it in, 80% for a modern wood stove or 15% for an open fireplace, which Penn State rates at 10-20%. The cost line uses the price per cord you enter, $340 by default, the middle of the $275-$400 HomeGuide reports for a delivered cord of hardwood in 2026. The comparison lines price the same heat from a 90%-efficient gas furnace at $1.48 a therm (EIA's 2025 residential average) and from electric resistance heat at 18 cents a kWh.

Treat the result as a planning figure rather than a guarantee, since burning habits and the specifics of your stove move actual consumption up or down. Not all firewood performs the same, either: seasoned hardwood delivers the best BTU output and burns cleaner, while green wood wastes heat and leaves creosote in your chimney. Be honest about insulation quality, too, because an optimistic rating leads straight to ordering less than you actually burn.

Example: Heating a Well-Insulated Small Home

  1. 1 A 1,200 sq ft home with 'Good (newer home)' insulation, a 5-month heating season and hardwood.
  2. 2 Heat need: 1,200 × 25,000 BTU × 5 / 5 = 30 million BTU. A modern stove gets 80% of a hardwood cord's 24 million BTU into the house, 19.2 million, so 30,000,000 / 19,200,000 = 1.6 cords.
  3. 3 Cost: 1.5625 × $340 = $531.25. The comparison lines price the same 30 million BTU at $493.33 from a 90% gas furnace (333 therms × $1.48) and $1,582.65 as electric resistance heat (8,792 kWh × $0.18).
  4. 4 Burned in an open fireplace at 15% efficiency, the same house would need about 8.3 cords, which is why Penn State Extension recommends a stove for heating. A heat pump would cut the electric figure to a half or a third.

Source: Penn State Extension — Heating with Wood: An Introduction · Last updated: October 2026

Frequently Asked Questions

How many cords of firewood do I need for winter?
For a 1,500 sq ft home over a 5-month season burning hardwood in a modern stove, this calculator estimates 2.0 cords with good insulation, 2.7 with average and 3.9 with poor; an open fireplace needs about five times as much. One cord is a stack 4 ft high, 4 ft wide and 8 ft long, 128 cubic feet (Penn State Extension).
How much does a cord of firewood cost?
Prices vary widely by region, species and whether the wood is seasoned and delivered, so get local quotes. HomeGuide puts a delivered full cord of hardwood at $275 to $400 in 2026; the calculator starts at $340, so enter your local quote in the price field. Green (unseasoned) wood generally takes 6-12 months to dry to about 20% moisture, the level Penn State Extension gives as optimal for burning.
What is the best firewood for heating?
Dense hardwoods produce the most heat: Penn State Extension lists an air-dried cord at 28.0 million BTU for hickory, 25.7 million for white oak and 24 million for red oak and sugar maple (the calculator uses 24 million for hardwood). Softwoods like pine burn faster with less heat output. For best results, burn seasoned wood with under 20% moisture content.