Generator Size Calculator

Calculate generator wattage needed based on appliances. Accounts for starting watts on motor loads.

By Konstantin Iakovlev · Updated September 2026 · Source: DOE · Methodology

Select Appliances to Power

Total Running Watts

2,700W

Peak Watts (largest motor starting)

5,700W

Recommended Generator

7,500W

Selected Appliances

Refrigerator700W running / 2,100W starting
Sump Pump1,500W running / 4,500W starting
Lights300W running / 300W starting
TV200W running / 200W starting

Generator Sizing

Total Running Watts2,700W
Peak Watts (largest motor starting)5,700W
Recommended Size7,500W
Load Factor36%

Fuel Consumption Estimate

Gallons per Hour0.6
Gallons per Day (24hr)13.9
Daily Fuel Cost (at $4.15/gal)$57.63

Use the Generator Size Calculator above to calculate your results. Enter your values and see instant results — all calculations run in your browser.

Disclaimer: This calculator is for informational purposes only. Results are estimates from the numbers you enter and the assumptions described on this page; check them against local building codes, product specifications and current prices, and have structural, electrical or gas work designed or checked by a licensed professional.

How It Works

Sizing a generator means matching its output to the appliances you actually intend to run, and that figure hinges on two kinds of wattage. Get it wrong in either direction and you either overpay for capacity you'll never use or end up with a unit that stalls the moment a compressor kicks on. The tool weighs both running and starting demands, with particular care for motor-driven equipment.

Calculation starts by totaling the running watts of every appliance you select from the list; each item has a fixed wattage (a refrigerator counts as 700 W, a sump pump as 1,500 W, central air as 3,500 W). Motor loads (the refrigerator, air conditioners, furnace fan, sump pump and well pump) draw about three times their running watts for a moment when they start. Peak demand is the running total plus that extra surge for the single largest motor, the method generator wattage worksheets use because motors rarely start at the same instant. The recommendation is the smallest of seven standard sizes, from 3,500 to 22,000 W, that covers the peak. The fuel line assumes about 0.75 gallons an hour for a 3,500 W unit at full load, scaled by the recommended size and your load (never below a quarter load), over 24 hours at $4.15 a gallon, EIA's U.S. average for November 2, 2026.

Counting only running watts is where most people go wrong. Loads like refrigerators and air conditioners draw far more power to start than to run, so that surge figure matters. Build in a 10-20% buffer for loads you add later or didn't anticipate, and account for the small stuff too, phone chargers and LED fixtures add up once you string enough of them together.

Example: Home Backup Scenario

  1. 1 Select Refrigerator (700 W), Sump Pump (1,500 W), Lights (300 W) and TV (200 W).
  2. 2 Running watts: 700 + 1,500 + 300 + 200 = 2,700 W. Peak: the sump pump is the largest motor, and starting it adds 2 × 1,500 = 3,000 W on top of the running load, for 5,700 W.
  3. 3 Result: the smallest standard size that covers 5,700 W is 7,500 W, which would run at a 36% load (2,700 / 7,500).
  4. 4 Fuel: (7,500 / 3,500) × 0.75 × 0.36 = 0.58 gallons an hour, about 13.9 gallons and $57.63 a day at $4.15 a gallon. Real starting surges vary by model, so check your appliances' nameplates.

Source: DOE · Last updated: September 2026

Frequently Asked Questions

What size generator do I need for my house?
In this calculator a refrigerator, sump pump and lights come to 2,500 running watts and a 5,500-watt peak when the sump pump starts, which a 5,500-watt unit just covers; adding the furnace fan raises the running load to 3,300 watts and the peak to 6,300, calling for 7,500 watts. Running central air and the rest of the house at once takes a much larger standby unit, best sized by an electrician.
What is the difference between running watts and starting watts?
Running watts is the continuous power an appliance uses during normal operation. Starting watts (or surge watts) is the extra power needed for the first few seconds when a motor starts, typically 2-3 times the running watts.
Can a generator run a central air conditioner?
Yes, with a large enough unit. This calculator counts central air at 3,500 running watts and, like other motor loads, at three times that (10,500 watts) for the moment it starts, so central air on its own points to a 13,000-watt generator. The real starting surge depends on the unit, so check its nameplate or ask an electrician.